Place: Home > Successful case >

ADSS Cable Suspension Clamp Installtion guide

It is mainly mounted on straight line poles or towers, the angle poles or towers for 25° of turning angles. The ADSS is hung up on the poles or towers with it, which will play supporting function, and one set of suspension clamp is mounted on each pole or tower. When the turning angle is between 25-60° or the span is relatively large, double suspension clamps are recommended to be used.

The standard suspension clamp should include: internal layer structural reinforcing rods, outer layer preformed rods, elastomeric insert clamp, casting aluminum shell, U-shape ring, bolt, nut, etc.

ADSS Cable Suspension Clamp

The Mounting Method of Suspension Clamp:
Step l : Mounting internal layer structural reinforcing rods. There is a mark on the middle part of the internal layer structural reinforcing rods. This mark is symmetric about the two ends of the structural reinforcing rods. The suspension clamp is mounted from the mark place, and the two ends of the mounted internal layer structural reinforcing rods should be even.

Step 2: Mounting elastomeric insert clamp. It is mounted at the mark place which is in the middle of the internal layer structural reinforcing rods.

Step 3: Mounting outer layer preformed rods. There is also a mark on the middle part of the outer layer preformed rods. The place of this mark should be in accordance with the mark place in the middle of the internal structural reinforcing rods.

Step 4: Mounting the casting aluminum shell in the middle place of the outer layer preformed rods, tightening the bolt.

Step 5: Mounting U shape ring, it is linked together with the fasteners of the pole or tower.
Send Enquiry

(Fields marked with * are required.)

Full Name: *
E-mail: *
Mobile:
Tel:
Country:
Messages: *